https://www.youtube.com/watch?v=sfnJ-_E-kmI
Tip 2. First start your device, w8 for 5sec, then add the Heet, the hot blade through that tobacco will create the right air channel
Tip 3: If you’ve already added the Heet through standard procedure and you’ve only then realize. that it’s not sucking… Pull over the cover, extract the Heet, push back the cover, rotate the Heet 90 degrees and insert back.
Tip 4: If you notice the Heet is over stacked before adding it, try repeatedly pulling the Heet out and back in, adjusting the angle. This will create grind the tobacco in the Heet, creating the airflow channel
Tip 5: Hard press and twist (Squeeze) the tobacco side of the Heet this will also grind the tobacco inside, helping the blade in going through it easier
https://www.reddit.com/r/iqos/comments/acwj1i/lately_the_heets_dont_suck_very_well/
In 2014, Philip Morris terminated her contract
Scientists describe problems in Philip Morris e-cigarette experiments (Tamara Koval) - https://www.reuters.com/investigates/special-report/tobacco-iqos-science/
#iqos
origin - https://www.pipiscrew.com/?p=14964 5-tips-if-your-iqos-2-is-not-sucking